2/14/2023 0 Comments Threading bobbin on singer 6211c![]() ![]() There doesn’t seem to be a clutch on the outside of this particular handwheel. These new Singers aren’t made very consumer friendly, and they are pretty hard to get inside of. ![]() She's A Sewing Machine Mechanic Novemat 3:35 PM If that fails, you can disassemble the bobbin winder, clean it, and put some oil on the shaft directly. Always blow the WD-40 out with an air compressor or canned air. First, I usually put some WD-40 in the cracks (top and bottom) and work it until it's loose. If it's hard to turn the top spindle by hand, it's probably frozen-up by old oil. Here's a couple pictures of a Singer bobbin winder. I neglected to mention that the bobbin winder spindle can become frozen as well. Screw the center knob back on and tighten the little screw. Turn the ring clock-wise one position (or two). If not, remove the center knob and re-position the metal ring. ![]() You should be able to release and re-tighten the center knob. (Take a closer look at the second picture above.) Then screw the center knob back on and tighten the little screw. Put the ring in place, with the nubs in the slots on the shaft. The raised side of the nubs should be facing outward. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |